                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:1954001
Semi-Circular Anet A8 Fan Duct by lokster is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

### If you use this fan duct & think it makes your prints look better, don't forget to TIP! ;)

This is my version of the "circular fan duct" for the Anet A8 printer (and other compatible printers).
Highlights:
- it's actually semi-circular. The circular one deforms after a while if printed in PLA (and I use/have only PLA), so I designed this version.
- it snaps to the fan a lot more securely (on the outside of the fan), and there is no chance of falling off during print.
- designed in such way, that the air blows just below the tip of the nozzle. The original design was blowing too far down.

Designed in Blender, by heavily modifying http://www.thingiverse.com/thing:1874390 - simplifying the mesh, adding the new attachment part etc.

Note: there is newer, and more effective fan duct I designed: http://www.thingiverse.com/thing:2133328

# Print Settings

Printer: Anet A8
Rafts: No
Supports: No
Resolution: 0.2